Lighter & 2 Smokes Case

pinshape

Friend asked if I could create a case for a Bic lighter and two cigarettes, new policy at work means no tobacco in the shop, so I came up with this solution and thought maybe someone else will find it helpful. Cura Settings: layer height 0.3, Infill 30%, Shell thickness 0.8, Bottom / Top thickness 0.8, print speed 50 mm/s - you'll need two screws, if you're like me, search through the junk bin or drawer for two that work; mark and drill holes for the screw not too big, test fit the cigarette cover, mine needed a little tweaking then take out the screw place a small amount of super glue into the screw hole being careful not to leave glue on flat surface and reinstall the screws if you get as lucky as I did this will produce a working cover and a nice way to carry two cigarettes and a lighter. HAPPY PRINTING!!!