Lighted Fireplace for RPG - Cheminee Eclairable RPG

thingiverse

This fireplace is derived from an excellent site, Hero's Hoard (http://www.heroshoard.com/inn-and-tavern), and enables a better visual effect with the integration of a led flame effect. The led used is https://amzn.to/32hnLI7. These are led to flame effect for photophores. I also used a support for battery 2032 https://amzn.to/2JQIuMx placed in Cheminee_Socle.stl. This battery holder has 2 vertical tabs intended to be soldered on a printed circuit. It will be necessary to fold them horizontally then solder the led respecting its polarity. To easily remove the battery, make a small hole in this holder, using a toothpick it will be possible to remove it easily. The led must be welded centered slightly towards the back of the support to easily install in the Cheminee_atre.stl part by simple clip. The impression made with an SLA Printer was made with transparent orange resin. During the painting phase, protect the flames which will have to paint very discreetly in red and yellow. The chimney is in 3 parts, so the 2 upper parts can be more easily painted and glued together afterwards. The fasteners between the pieces are very tight, clip the pieces together several times to make them coincide. Add-on: If you want to glue the 3 parts, use the part Cheminee_atre_percee.stl. Put in place the 2 lower parts with the battery holder in place, which you will drill in front of the hole of this part. With the 3 parts glued, the insertion of a stylet by the top of the chimney will allow you to remove the battery without difficulty.