Light Up Flower Pot using LED Strips

prusaprinters

This is a fun little flower pot you can insert a 10-12mm LED strip into.  You can also build the LED controller for this (or use a pre-made strip).  https://thangs.com/designer/Makers%20Mashup/3d-model/ElectroCookie%20Enclosure%20for%20WLED%20Projects-760374?manualModelView=true&source=RecentIs an enclosure and LED controller.  I show you step by step how to wire one.Some tips for the Light Up Flower Pot1. Using a dark filament you wont get many colors but it will completely hide the LED's.  So when it lights up, youre not expecting the lights to show through. 2. This works great outdoors as well as indoors. 3. You can scale up the pot, but you cant scale it down since the channel for the LED's would shrink. 4. Use a zip tie to hold down the wire in the back.  There is a groove for the zip tie in the pot. 5. Translucent filaments will light up very well.  6. One controller can power a few pots at lower power.  The LED's dont have to be very bright to have a huge effect.Was this model helpful for you? Consider supporting my work in any of the following ways! Even the free options help the channel!Consider dropping a tip https://koji.to/k/8E9J or consider supporting my ongoing work https://www.patreon.com/makersmashup Purchase anything on amazon after visiting our store page https://amzn.to/429HusI. Just click this link first!No cost option to support my work?- Subscribe to the YT channel- Follow me on Thangs.com- Watch videos on the channel!- Share any of the videos on social media!- Share my models with friends and family!