Light Switch Cover

prusaprinters

<p>This is a plain, ordinary, everyday light switch cover. There's nothing particularly exciting about it.</p><p>I created it since it was tough to find a plain cover that looked properly sized and reinforced that could print well. I modelled it after a cover that I had around. The edges are angled rather than the usual smooth curves since similar models with smooth curves were difficult to print due to the overhang.</p><p>This model should be printed with the visible side (side facing out when on the wall) against the print bed. No supports are necessary. Infill is up to you - there is so little that it likely won't have any effect on the print.</p><p>The print seen in the photos used 0.2mm layer height, no supports, 100% infill, using Overture Matte Green, sliced in PrusaSlicer, and printed on a Prusa Mini+.</p>