Light Bird Temple Free 3D print model

cgtrader

This Bird Feeder boasts an innovative design featuring a built-in lamp. The lamp is positioned in the feeder component and shines upward. The lamp is actually an RGB LED strip, enabling it to change colors. Efforts were made to engineer the feeder section so that water can effortlessly drain through an integrated channel. Given the presence of the lamp inside, it's simple to disassemble this feeder for future fixing purposes. In the center of the pillars sits a cylinder (lamp glass roof.stl), printed with translucent PET-G, where the IR receiver is located. This setup allows the remote control to remain functional. If you don't have access to a remote control, you can utilize this section to install an additional lamp. The placement of the "ROOF PART with cable bore.stl" might appear unusual but functions exceptionally well. Printing guidelines for those who desire a clear understanding: The base.stl is printed at 30% infill and four wall lines/layers using PLA. Foundation components are printed with 10% infill and four wall, bottom & top lines/layers in PLA. Lamp glass or feeder part.stl is printed with 25% infill, three wall lines, three top layers, and two bottom layers using PET-G. The lamp glass roof.stl is also printed at 25% infill, but with only two wall lines, and featuring three top and two bottom layers made from PET-G. Mount STL's are printed at 35% infill and four wall, bottom & top lines/layers in PET-G Carbon. Pillars are printed at 10% infill and feature four wall lines/layers made using PLA. The roof parts are similarly printed with 10% infill, consisting of four wall, bottom & top lines/layers in PLA. Spires, on the other hand, have a printing infill level of 20%, four wall, bottom & top lines/layers all utilizing PLA. (A critical consideration to prevent warping, particularly at spiky tips/ends.) Ensure low heat bed temperature for these print requirements.) Parts needed: * 1 x base.stl * 2 x foundation part with bore for cable to the base.stl (Note A) * 2 x foundation part with bore for cable to the base.stl (Note B) * 4 x foundation partA.stl * 4 x foundation partB.stl * 1 x lamp glass or feeder part.stl * 1 x lamp glass roof.stl * 1 x mount second peace.stl * 1 x mount with bore.stl * 2 x pillar with bore for cable to the base.stl (One is mounted on each side.) * 6 x pillar with mounting for base.stl * 6 x pillar.stl * 12 x ROOF PART with cable bore.stl * 6 x spike foundation part.stl * 6 x spike roof.stl * 6 X M3x20mm bolt & nut (An extra three bolts are provided, although not needed for a normal build.) * 1 X M3x60mm bolt & nut (Or opt to use two nuts and a 60 mm treated rod like myself did.) * 1 X lamp or LED designed for mounting inside. Super Glue & Universal Glue is required for the base feeder part.