Light Bar for Ender 2, and switch

cults3d

Updated thanks to an error found by jbidinger, thank you!. the pulley wheel must be mounted to rear of the X-gantry to have full movement of X carriage. As such I made a new version c which has a cut away for the mounting plate on the rear. Here is a light bar you can mount to the rear of your X gantry with 2 T slot nuts and screws. I used this light roll: http://a.co/2jMP1eH cut at smallest interval that is indicated on the roll. You will have a lot left over that you can use with any 12V source. I then wired it to the rear of the Power Supply, positive lead goes to the V+ lug and negative to the COM. I added a switch in the middle that I screwed to the side of my control box. I am including my files to the switch. I used this part: 5pc OLS 12V DC 30A 3-Pin SPST LED On/Off Rocker Switches - BLUE http://a.co/i9y5ln0 or you can print this control box with built in switch placement: https://www.thingiverse.com/thing:2706488 you can use with this switch housing:https://www.thingiverse.com/thing:3315172 If you make one please let me know, and post your photos.