Light Bar for Ender 2, and switch

thingiverse

I made an update thanks to jbidinger's error report, thank you so much! The pulley wheel needs to be mounted at the rear of the X-gantry for full movement of the X carriage. So I created a new version c with a cutout for the mounting plate on the back. Here is a light bar that can be mounted at the rear of your X gantry using 2 T slot nuts and screws. I used this light strip: http://a.co/2jMP1eH Cut it at the smallest interval marked on the roll, you'll have plenty left over to use with any 12V source. Then I wired it to the back of the Power Supply, with the positive lead going to the V+ lug and the negative to the COM. I also added a switch in the middle that I screwed onto the side of my control box. You can find my files for the switch here. I used this part: 5pc OLS 12V DC 30A 3-Pin SPST LED On/Off Rocker Switches - BLUE http://a.co/i9y5ln0 Or you can print this control box with built-in switch placement: https://www.thingiverse.com/thing:2706488 You can also use this switch housing: https://www.thingiverse.com/thing:3315172 If you make one, please let me know and post your photos!