life sized companion cube printed edges and corners

thingiverse

this is my final versions of the edges and corners of a weighted companion cube from portal and portal 2. these are great games, go play them and support the original creators! 3d models created for free at tinkercad.com you can do it, too! instructions, plans, and cut files coming soon! all models made to fit on stock ender 3 corner secondary updated to correct scale 1/24/23 print settings (based in Cura 4.13.1): corner main: (QTY. 8) the hole is to support a 2x2 wooden dowel, make sure that face is faced down. should weigh less than 650G layer height: .2mm infill: grid at 5% wall count: 2 / 0.8mm support: tree, everywhere, 45° adhesion: BRIM 8mm corner secondary: (QTY. 24) print is symmetrical, but make sure one of the sharper corners is facing upwards. should fit 3 copies on an ender 3 buildplate. should weigh about 100G each layer height: .2mm infill: gyroid at 7% wall count: 2 / 0.8mm support: tree, everywhere, 45° adhesion: OFF edge: (QTY. 12) orient so the insides are facing down, this will keep the smooth side needing less finishing. should weigh less than 200G layer height: .2mm infill: gyroid at 7% wall count: 3 support: tree, everywhere, 45° adhesion: OFF