Lidl Powerfix torx wrench holder - Voronoi

thingiverse

This is a remix of G3ox's Powerfix torx wrench holder, all I did was added voronoi holes to its flat sides to save material and add a twist to its design. The tools do not fall through the gaps on the bottom, the part's rigidity is maintained. Printed fine without supports at 0.28mm layer height from PETG, with a wall count of 2 and 15% infill, just make sure to enable thick bridges. A brim is recommended. If you want you can add supports and also print at a lower layer height to improve quality, in the case of snug supports the material use will be around the same as the original part without the voronoi holes - but with the added satisfaction (or the pain :) ) of popping the support material from all the holes.