Lidl Glider flying wing motor mount

thingiverse

This is a straightforward motor mount designed for a Lidl glider modified as a flying wing by severing the tail. It attaches to the rear of the fuselage just past the wing, where I cut mine. Approximately three degrees of downthrust are built into the motor mount, which seems necessary for my aircraft to prevent it from climbing every time I throttle up. Feel free to modify the files found here: https://www.tinkercad.com/things/iuzn3cPcAEy. If you need more or less down thrust. Any 16/19mm M3 bolt hole pattern brushless motor should fit onto this motor mount. I suggest taping over the back of the fuselage where you cut it short, then use hot glue to attach the motor mount to the taped surface. This allows for easier removal of the motor mount later, especially if you don't overdo it with the hot glue, without damaging the foam.