Li3D Light for Wanhao Duplicator i3 / Maker Select

thingiverse

BETTER PICTURES WILL COME! The Li3D Light is an extremely compact 3 led light designed specifically for the Duplicator i3 printer. It's incredibly useful when printing in areas with poor lighting conditions, and at the same time provides minimal obstruction of the part being printed. Works exceptionally well together with the CiiiCooler. [CHOOSING THE RIGHT PARTS] V1.0 and V2.0 - LeeeD_Light_Cover_1-1 and LeeeD_Light_Holder_TypeA_1-1 V2.1 - LeeeD_Light_Cover_1-1 and LeeeD_Light_Holder_TypeB_1-1 [REQUIRED HARDWARE] 1 pc LED Board Strip (Use the white section after breaking off) 2 pcs M3x8 screw or longer (For V1.0 and V2.0 machines) 2 pcs M3x14 screw or longer (For V2.1 machines) 2 pcs M3 nut (or locknut) Cables, connectors, and soldering skills. [MOUNTING INSTRUCTIONS] 0) Clean up the parts from the skirt and vertical supports of the cover. 1) Solder wires to the PCB of appropriate length for your printer. (Preferably too long and cut later to size.) 2) Place the LED board with the back into the holder in the slot shown on the assembly picture. 3) Route the wires according to the assembly picture. 4) Place the cover on top of the LED board assembly picture. 5) Place nut into nut socket and fasten with the screws through the mounting bracket of the printer. 6) Make sure the LeeeD light is wired in parallel with the extruder fan (always on). [ATTENTION] If you short-circuit any part of this assembly, you might damage your printer. Please be careful. You have been warned! [DONATIONS] If you find that the item improves your daily life, consider supporting the designer by sending a tip. Click "TIP DESIGNER" here.