LGX FF Mount for CR6

thingiverse

This is a Mount for the Bondtech Large Gears eXtruder With For Flexibles Set (LGX FF) to attach it to the Creality CR-6 SE The Nozzle is moved 3mm to the front compared to the original position it's also about 1cm lower so be sure to adjust the z endstop otherwise the print head will crash into the bed. The clearance between the lever and the "scale" and between the LGX and the bottom wheel screw of the gantry are pretty tight but it just about fits. Use the longer 30mm m3 screws which are in the FF Set. The top left m3x10mm screw is replaced with a m3x14mm screw. Two m3 nuts are inserted into the mount. The fan duct is from the [hero me 5](https://www.thingiverse.com/thing:4460970) and requires a 5015 fan and should be positioned ~1.6mm higher than the tip of the nozzle. (move nozzle to 0mm and put some 1.6mm thick thing under the fan duct then fasten it with the screw) Attaching the fan requires 2 m3 nuts (optionally 2 m3 washers for the height adjustment screw and the left fan attachment screw) and some additional screws. 1x m3x6, 1x m3x8, 1x m3x10, 1x m3x20 The mainboard dosn't have a holder and is floating at the end of this [cable support](https://www.thingiverse.com/thing:4654645)