lg g4 case

thingiverse

NOTE: Check the printer settings notes section after searching for hours I could only find three 3D models for an LG G4 however they were all a different model of the G4 which has a different sized back camera along with different placement of receivers such as this so I created my own. I believe that this is actually the only case for this model online. Note: As of now, I'm still playing with the size. It does not fit the phone yet slightly too small. If anybody prints one and the size is right please measure it and message me so I can update the model. Print Settings: Printer: Hictop Prusa i3 Rafts: Yes Supports: Yes Resolution: 0.1 Infill: 100% Notes: Print with 1 mm wall thickness 0.2 mm outer wall inset 0.2 mm horizontal expansion these settings are not shown in Cura by default you will have to open the extra settings in the shell category Model will print with hollow side walls unless these settings are changed. Post-Printing: The holes at the bottom of the model are very messy they will likely need some drilling and or scraping to make smooth.