Lezyne GPS Bike Mount

thingiverse

The Lezyne GPS Bike Mount has been reworked with some tweaks to make it easier to print in 3D. I printed this mount using PETG, but you can try other filaments - just be aware that PLA might not work so well. A 50% infill is a good choice for maximum strength and good layer adhesion. Supports are recommended with a 70-degree setting. The main bracket can be printed as usual, but the clamp works better when it's on its side. To assemble it properly, you'll need two M4 allen key heads and Nylock nuts for the clamp. Additionally, some foam or rubber inside the clamp will help protect your bike from scratches.