Lever n°2 for Virpil/Thrustmaster Joystick Grips

prusaprinters

Press Like for encouragement. Comment for improvement.The lever has been moved to the right to give way to a lever/switch on the grip.Materials:M3x 10mm bolt + nut.M3x 16mm bolt + nut.an optional compression spring (5mm in diameter, 20mm in length and 0.8mm wire diameter).a rotary potentiometer.a 5-pin JST PH male connector (plugged into the Virpil base).Electronics:Plug the potentiometer wires either:on an Arduino Leonardo/Pro Micro, get the joystick library and follow the examples in Arduino tutorial chapter 3.on a Leo Bodnar BU0836,on the Virpil base board:Check first if your circuit board looks like mine on the picture. On the joystick's base, look at the bigger circuit board. Look for the 2x 4-pin connectors (1 on each side, each one for a hall effect sensor) There are 2 free pins next to them. That's where the signal from the potentiometer goes. Take the + and the ground from the free “AUX” 5-pin connector. Check the picture for more details.When the wiring is done and the grip is connected, open the VPC Configuration Tool, define 2 new axis (double click on a free axis) and calibrate them. That's it. Just take your time, it's easy.Notes: If you own a Virpil, this variant is more resilient.3D-printed plastic isn't as resilient as the grip.If you can make the structural parts out of resin: do. If it's not an option: use PLA or better, choose at least 90% infill and print the parts with an angle (potential crack to filament layer). Adapt the joystick response curves so you don't yank your stick like a mad man. Then it'll be fine.