Levelling feet for Creality CRX and Others...

thingiverse

Leveling feet designed specifically for the Creality CRX 3D printer and compatible with other similar models require careful installation to ensure precise positioning of the printer's frame. To achieve this, follow these steps: First, locate the leveling adjustment holes on your 3D printer. These are typically found on the X-axis gantry or near the bed. You may need a small wrench or Allen key to access them. Next, loosen the leveling feet by turning the adjustment screws counterclockwise until they are free from any tension. This will allow you to make precise adjustments without over-tightening the feet. Now, position your 3D printer's frame on a level surface using bubble levels or other tools to ensure it is perfectly flat. If necessary, use shims or spacers to adjust the height of the printer until it is perfectly level. Once the printer is properly aligned, tighten the leveling feet by turning the adjustment screws clockwise in small increments until they are snug against the frame. Make sure not to overtighten, as this can cause damage to the printer's components. Finally, perform a test print or verify that your 3D printer is functioning correctly before proceeding with any further adjustments or prints. By following these steps, you can achieve precise leveling of your Creality CRX and other compatible printers, ensuring optimal performance and accurate prints.