Level your Leaning Flatscreen TV!!!

thingiverse

I have a SONY KDL-32CX520 that leans severely. Two of these might be the answer. Each one requires a 29mm support under each side. To fit your TV perfectly, measure the correct height (Lower side + Higher side /2) from the TV to the tabletop. Then Scale to Fit, based on 29mm of height (and 71mm long). Length is not crucial; you can cut off the rear tab if it's too short. For instance: If your TV needs 35mm under each side, scale it by 121% (35/28=1.21). If it needs 25mm on each side, scale it by 86.2% (25/29=.862)... and print! I paint my PLA matte black, but let it dry in a cool place to prevent shrinkage! Print Settings Printer: Da Vinci 1.0 Pro Super Modified Rafts: No Supports: No Resolution: .300 Infill: 25% Notes: Print standing up or on its side; either should work well!