Level check Da vinci Junior

thingiverse

This was created with the XYZ Da Vinci Junior in mind. This is a straightforward testpiece to verify: 1) if the bed is level 2) adhesion to the bed I print this after: a) X-axis calibration to check the even level of the bed b) check the adhesion to the bed after Z-offset changes After printing, you can check: a) If the bed level is correct, the thickness should be the same all around the part. If this isn't the case: calibrate X-axis b) if adhesions to the bed are okay, it should stick the same all around the part. If this isn't the case all around: calibrate X-axis. If it's not sticking in general: correct Z-offset.