Lens hood LH-76D for Olympus ED 100-400mm f/5.0-6.3 IS

thingiverse

I created this lens hood for the Olympus micro four-thirds 100-400mm non-professional lens, which takes an LH-76D hood. If you want to check whether it will fit your lens, the outer diameter of the end of the lens should range between 75-77mm and the diameter of the lens cap is around 74mm. The original lens cap was 60mm, which was too long to fit in my bag, so I made a 30mm one instead. It probably won't provide as much glare protection as the 60mm one, but it's better than nothing. I based the design on the prototype measurements, but had to scale it up slightly (101.2%) to get the printed one to fit. This scaling is included in the STL, but if your printer is more accurate then you may need to scale it back down.