Lens Cover and Controller Holder for Oculus Go

thingiverse

You can now order the Oculus Go Lens Cover from here - https://www.etsy.com/listing/749543956. Please note that this cover does not fit the Oculus Quest or Rift S, and you can purchase one that fits from our Etsy store at https://www.etsy.com/shop/BaptieWright3D. This design is available for private non-commercial use only, and any commercial production of this design or its derivatives by anyone other than me or ogovrgear.com violates copyright law. Lenses on VR equipment are very sensitive to sunlight, and the Oculus Go headset comes without a cover or case. I designed a fitted protector for the lenses that also incorporates a holder for the controller. The design is in two pieces, which can be printed flat. The controller holder snaps into place and is rotatable, but it's a little tight to fit. There is an alternative version of the cover without the logo and with the controller hole moved to the center. An update was made on 5/27/18 adding v2 of the controller holder with the "snap" rotated 90 degrees for printing without support. Another update was made on 7/21/18, splitting the design into two versions that can be printed on beds around 100mm square. One version is a straight split down the middle and the other has an overlap to allow more gluing surface, but it's only 96mm long so very close to the edges on smaller printers. A further update was made on 10/17/18 adding v3 of the controller holder with a center ridge that holds the controller in place. Finally, an update was made on 12/25/18, uploading a new version by request without a hole for the controller holder.