Lennon by Warhol

thingiverse

Tribute to both Andy and John. To produce this print, you will need three filaments: black, red (or orange), and blue. Use PLA or PET-G filaments; avoid using transparent filaments. First, use the black filament. At a height above 1 mm, switch to the red filament. At a height above 2 mm, switch to the blue filament. For a layer height of 0.2 mm, these changes will occur at 1.2 mm and 2.2 mm respectively. Ensure your slicer can handle filament changes or pauses at predefined heights. Depending on the filaments you use, there may be some stringing present. You can try to remove it with a heat gun; however, be cautious not to deform the thin print. The dimensions of this print are approximately 150x150 mm. If you decide to scale it down, check in your slicer beforehand for lost details.