lemon bolt

thingiverse

For years I relied on a low-cost, plastic device purchased in Istanbul. Squeezing lemons was effortless, enjoyable, and sanitary. Eventually this gadget failed, prompting me to design one tailored specifically for 3D printing. The lemon-bolt is simple to print, featuring no steep overhangs, and ready for use directly from the printbed. Instructions: - Optional: Roll the lemon on a surface to extract even more juice. - Press and screw the lemon-bolt into a lemon until it will not penetrate further. - Massage or squeeze the lemon, allowing the juice to flow freely. - If all the juice is not required, store the lemon with the bolt attached in the refrigerator. View the accompanying video: https://youtu.be/cFkVLB6J7Ig (apparently, I acquired the most fragile lemon on earth...)