lego_slope

thingiverse

Instructions Using the following options: slope_end_height: zero vertical_axle_holes: off block_width: two units long curve_end_height: equal to nothing slope_stud_rows: just one line of studs curve_stud_rows: three lines of curve-shaped studs wing_stud_notches: don't make notches in the wing studs stud_type: made out of solid pieces wing_end_width: measures two units wide block_length: comes in a length of two units wing_base_length: the base length is four units block_height_ratio: one unit tall as the width technic_holes: don't use technic holes block_brand: Lego use_reinforcement: not needed curve_type: makes concave curves block_type: type is a slope