LEGO Hexagon Ecto-1 / Speed Champions Shelf

prusaprinters

<p>I decided I wanted to be able to display my LEGO Ecto-1 in the middle of my Hexagon MiniFig Display that I've been printing thanks to Casadebricks.com's Extended Minifig Hexagons. So I created this shelf specifically for that particular layout (kind of nestled in the middle), and wanted to share in case someone would enjoy the same.&nbsp;</p><p>After printing I did some revisions, and at the same time I also realized it will work with the Speed Champions series as well. (Some of the pictures with the Speed Champs are on my first test print before revising). So I made a few variations:</p><p>Hex Display Ecto-1 Mount - Variation 1 Deep &nbsp; &nbsp;Is, as pictured, if you want it to have the “upper” keyways for mounting in the middle or recessed into the display. (Also works for the wider Speed Champions cars)</p><p>Hex Display Ecto-1 Mount - Variation 2 Deep &nbsp; &nbsp;Is without the “upper” keyways in case you want to mount on top of the display. (Also works for the wider Speed Champions cars)</p><p>Hex Display Speed Champ Mount - Variation 1 Shallow &nbsp; &nbsp; &nbsp;Is for the narrower Speed Champions cars and has the “upper” keyways for mounting the middle or recessed into the display.&nbsp;</p><p>Hex Display Speed Champ Mount - Variation 2 Shallow &nbsp; &nbsp; &nbsp;Is for the narrower Speed Champions cars, without the “upper” keyways in case you want to mount on top of the display.&nbsp;</p><p>I made a couple “short” variations as well (deep and shallow). Ecto-1 is too long to fit on these, but should be good for the wide and narrow Speed Champions respectively.&nbsp;</p><p>Also pictured, I used the “Short Variation Shallow” to display the 4 Ghostbuster Minifigs in on their display, just under Ecto-1.</p><p>&nbsp;</p><p>I printed in PLA+ with the cooling turned down a bit. I also recommending printing with a brim.&nbsp;</p>