LEGO HEAD Remix for dimension and fit

thingiverse

This remix addresses two things: * The original head did not fit well to the post on the body (too loose). With calipers I measured the post at about 23.85-23.9mm. The ring on this remix is set to 24.4mm allowing a ~0.25mm gap in all directions, giving a firm fit but still removable. Test printed in PLA and it fits well. Your mileage may vary of course. * I felt the head on the original was a bit narrow. Using a reference image, I calibrated for a 5x size model in diameter (51mm) and then followed the image. It isn't perfect but I think it represents a model closer to the original dimensions at this scale. The crossbars in the upper hole were removed. A sloping fill was added to the upper interior overhang so the model can be printed without supports. Since the footprint is rather small, I printed using a raft to ensure it would not pop off during the print. Thank you to the original author for the inspiration!