Lego Armor revised

thingiverse

Here's a slight tweak of the Lego armor by Printermagic, expanding the neck piece and adding some extra space to the front-back section. This is just a rough mod, but I felt that the original looked a bit weak on account of its slender shape. Results may vary, so you might need to make some adjustments. Printing Instructions This model was printed at a 0.2mm layer height, with two shells and no infill. The armor's orientation was set vertically to minimize distortion around the neck opening. Note that while the original design is quite accurate, it might be a bit too narrow in the chest area. This revised version has been sized specifically for printing on machines like a Replicator2, which often produce slightly smaller results than anticipated.