Lego 1x3 98

thingiverse

Created with Customizer! Instructions Using the following options: road_x is at its lowest point. road_y is also set to 0. wing_studs are marked for removal from the design. Wings will be built to their full extent. The length of the wing base has been extended to 3 blocks. Extra support has been omitted from this build. Blocks are stacked with a width of 1 block. Roadways have not yet begun to take shape. Ratio of blocks in height is at its maximum level. A curve with five stud rows runs throughout this model. The final section of the slope's end will reach ground level. A single row of studs for the slope supports the weight. This curved pathway features concave edges. Each block built resembles a single brick unit. Curves come to an end before reaching top floor height. Roadways measure their width at zero blocks wide. Vertical axle holes are not integrated into design. Reinforced material will be avoided in this model build. End of wings reaches 2 units across from starting point. Metal rods supporting structure remain solid throughout.