Left-Side Creality CR6 CR-6 SE Extra Drawer - Flat and Stronger

thingiverse

Props to the original maker. I remixed the long version of the original drawer to have a flat front and a stronger handle - just like my right-side remix here. https://www.thingiverse.com/thing:4703142 You can see my matching right-hand drawer here https://www.thingiverse.com/thing:4703142 I also beefed up the sections that go into the v-slot extrusion as the originals were just thin lines and didn't hold it in place - I had to use double-sided tape on the bottom to make mine stay where I wanted it. Just like the right-side drawer I glued magnets onto the drawer and drawer holder to make it stay shut and once the glue dried I covered them with black electrical tape. Next I need to design some inserts to separate out all my bits! I have a cover over my SD and USB slots so I needed to have this back a couple of mm so I've included stronger v-slot covers at 28mm and 30mm. I didn't actually use these as I made a z-stop cover to go behind it instead you can see here. https://www.thingiverse.com/thing:4707229 See my make for lots more photos. I can't be bothered to resize all of them to be under the stupid 500k restriction that Thingiverse put on images for things but not makes! UPDATE: I made a drawer splitter to go with it (it's 2mm smaller in length due to me using a magnet inside the drawer.