Left handed duplicator 6 blower cooling duct with probe mount

thingiverse

Added 1bigpig's 12mm probe mount, offsetting it 5mm further right to ensure accurate calibration. Update firmware config with these revised lines: #define X_PROBE_OFFSET_FROM_EXTRUDER 40 // Correct X axis offset from extruder #define Y_PROBE_OFFSET_FROM_EXTRUDER -16 // Accurate Y axis offset from extruder Improved printability by connecting nozzles to the main part from the first layer, preventing them from detaching during printing. Removed 0.2mm from the bottom of the part to enhance surface area and added a helper disc that can be easily cut off, preventing the circular part from lifting off during initial layers. Note: Supports are required for the probe mount. Manually add supports in your Slicer near the fan mounts inside the circular part where the roof is horizontal. Avoid over-supporting, as it may become challenging to remove. Print Settings: Notes: Do not use PLA or PETG; they will sag if printed above 200C, even with a silicone boot.