Left Duct Skinny Remix

thingiverse

This remix only updates the left fan duct to widen the gap between it and the heating block to 3.5mm from 0.5mm. The original design was printed in ABS, which started to warp due to heat after several prints. The current green model illustrates the warping of the left duct. The new red version has not yet been installed. 7/17/2019 Months after updating this design, I've had no issues with the duct warping like it did in the original design. Printing materials at temperatures up to 235c so far have shown that the extra spacing was just enough to prevent warping. A homemade silicone boot helps regulate temps and should be used by everyone. 4/26/2019 The updated left duct has been installed, and everything looks good so far. The height is as expected, and I've printed at 240c for over five hours without any signs of warping like the original duct had. Some pictures of the red model installed are posted now.