Lee Load-All 2 65mm (2 1/2") Adapter Kit

thingiverse

65mm (2&1/2") shotshell adapter kit for Lee Load-All press.Dimensions stolen from Theophys here: https://www.thingiverse.com/thing:5144100Installed on a 67.5mm variant of the Lee Load-All press, your press may be different so the height of the crimp extension may need to be adjusted accordingly. Spacer changed to accept a countersunk M8 bolt with the head reduced in diameter to 14mm, should not take much, I used a lathe but a drill & angle grinder will do the same job.A 14mm x 3mm round magnet can then be placed on top of the bolt head to hold cartridges in place.Ensure the position of the spacer is set such that the tube slides easily over the cartridge when in place, there is some wiggle room in the base but once the correct position is found the bolt should be tightened to lock it in place.An M3 nut should be dropped into the crimp extension where the hexagon shaped hole is, this is to accept a 60mm M3 bolt to remove the spacer when required.