LED tape strip light holder 8mm strips

prusaprinters

<p>A quick clip to hold your LED light strips. These are for the type that come on spools, snug for 8mm wide ones. I made 2, one is smaller designed for double sided tape and the other has counter sunk holes to fit 4mm screws.</p> <p>I made this because the tape on the back was never enough to hold them. These also allow you to move them later if you want. They are made to go with a 25mm (close to an 1") square of tape.</p> <p>Added a 10mm strip version.</p> <h3>Print instructions</h3><p>Don't use supports. These are designed to print at 0.2 layer height. They are so thin infill won't matter. The clip has built in support when they are done it is easy to free with a box knife. Since it has a longer bridge, it's best to use part full fan. PLA should work fine.</p>