Led Support HK Fabrikator Mini 2

prusaprinters

<p>This led support suits the HK fabrikator mini 2. I used this device <a href="https://www.banggood.com/Remote-Controller-11Keys-Mini-Dimmer-for-Led-Single-Color-Strip-DC-12V-p-91895.html?rmmds=myorder">https://www.banggood.com/Remote-Controller-11Keys-Mini-Dimmer-for-Led-Single-Color-Strip-DC-12V-p-91895.html?rmmds=myorder</a> for remote control of 3 leds on each side of the printer</p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>fabrikator mini 2</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>No</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.2</p></div> <p><strong>Infill:</strong></p> <p>10%</p> <h3>Post-Printing</h3> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/d0/d7/f5/3b/fc/IMG_2955.jpg"/></p> <p class="detail-caption"><strong>location of wires where to solder input of led controler.</strong></p> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/08/31/c3/b8/a6/IMG_2956.JPG"/></p> <p class="detail-caption"><strong>Ground wire (black) is solder on the main plug of the board (easy to remove the plug and the cable to solder on top)</strong></p> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/b6/6e/42/f7/81/IMG_2957.JPG"/></p> <p class="detail-caption"><strong>12V wire is solder on the main 12V from the back of the switch. Thus i don't need to switch on the printer to get the led on, i can control the led without switching on the printer. Again easy access to the wire, no cut needed.</strong></p> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/e1/e2/5d/3d/e9/IMG_2959.JPG"/></p> <p class="detail-caption"><strong>Red and black wires soldered to the input of led controler</strong></p> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/70/72/60/ce/ec/wiring.png"/></p> <p class="detail-caption"><strong>soldering cables from the output of led controler to both led support.</strong></p> <p class="detail-title"><strong>Soldering instructions</strong></p> <div><p>Solder the input of led controler to the black wire (taken on the plug of the card) and the red wire (taken on the switch. You can easily remove both wires to solder a cable here and then put them back in place (no need to cut any wire).<br/> Then solder black and red onto the same cable for both the 2 leds supports as shown on the draw. </p></div></p></p> Category: 3D Printer Accessories