LED Strip Mount / Shroud for Robo R2

thingiverse

There are two mounts, each following the curve of the printer precisely. One mount angles sharply downwards at a 45-degree mark, while the other has an even steeper downward angle of 67.5 degrees to reach the LEDs easily. To prevent excessive light overspray, a small front valance is added to the model. The strip can be stuck securely right on the inside edge of the top and uses double-sided adhesive to stick firmly to the printer. The main differences between this design and item 243665 are the steeper angles for the LED strip's straight mounting surface and a flat section instead of the curved one in the original, located only at the back.