LED strip mount for Robo R2 printer

thingiverse

I was fed up with the dim lighting on my R2, which is basically useless in its stock form. So, I decided to install two 12-LED long strips of LED lights on top. This mount perfectly follows the curve of the printer and gives a 40° downward angle to the LEDs. The strip can be stuck directly on and secured with double-sided foam tape. Both pieces of 12V strip are connected in series and plugged into the 24V power input located behind the power switch (the first two pins of the green connector, as shown in the photo). When printing, it's essential to use a temperature-resistant filament. PLA will warp if exposed to heat from the printer bed for an extended period.