LED strip holder with wire management for all CR10/CR10 V2 variants

thingiverse

A custom LED light bar remix, inspired by Kondrez's original design. The goal is to create a neater wire management system using the additional channels on the back or extension of the right-hand arm. This remix is designed specifically for two 22AWG wires (+/-) that can be seated snugly in the channel and directed down to the 2040 extrusion, allowing for easy routing to the printer's PSU. To secure the remix to the 2040 extrusion, two M3 bolts and two nuts are required. Printing with supports is recommended, as they come out easily from the recess. However, bridging without supports can be done at your own risk, since wires may not sit flat in the recess due to sagging of the bridged section. Remember to use an LED strip that matches your printer's voltage and amp requirements, ensuring safe operation and optimal performance.