LED strip holder with landing pads

thingiverse

I'm adding an update. Installing the LED strip into a small area, like behind a projector screen's edge, proved to be a bit of a challenge. Fortunately, the little tabs on each pad make it easier to slide the strip in place. This time I've spaced these out about six inches from one another. Using brown filament for this version has been straightforward. Keep in mind that I designed this holder specifically for non-waterproof strips, but I haven't had a chance to try it with waterproof ones yet. The screws used are #4 x 1/2" flat head, which fit snugly into the holes. This set of instructions printed without any issues using regular settings.