LED Strip Holder for Prusa Lack Enclosure

thingiverse

Rather than let the LED strip dangle untidily from the lid of the Lack enclosure I decided to make a more rugged job. I have used PETG for my example as I know PLA will warp by the heat generated within the enclosure. No soldering is required. Apart from the printed parts you will also need LED Strip (24v) https://www.amazon.co.uk/gp/product/B07B9ZD6N5/ref=ppx_yo_dt_b_asin_title_o06_s00?ie=UTF8&psc=1 Right angled connectors https://www.amazon.co.uk/gp/product/B077X7ZQLC/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1 16 x Screws https://www.amazon.co.uk/Stainless-Crosshead-Drilling-Self-Tapping-Woodworking/dp/B079PPJTZF/ref=sr_1_14?dchild=1&keywords=wood+screws+m3+3mm&qid=1602973003&s=diy&sr=1-14 Note The LED strip has polarity. See photographs. To aid insertion of the strip into the right angled connectors it is advised to slightly lift the connector pins. They will close and make correctly when the connector is closed up. If you have cut the strip too short at any point just use remaining strip on the reel, there is absolutely loads left over so don't worry about cutting incorrectly. 2 methods of power connection are available. Either hard wire or use a 2.1mm jack. One of the corner covers has an opening for the cable, so make sure you identify this one and reserve it for the correct corner. One stl file contains the complete set of parts, but for those with smaller build plates the parts have been provided as separate files for your convenience.