LED-strip holder for Anet A8

thingiverse

I upgraded my printer using the "Anet A8 renfort arrière by M2orea" but it didn't quite work as planned. So I decided to repurpose it into an LED strip holder instead. To make this, you'll need to cut it in two pieces since it's too large for a single print job on my Anet A8. Assembling the holder requires a 40cm long M8 threaded rod and some washers and nuts - just check out the pictures to see how it all comes together. Print Settings: Printer: Anet A8 Rafts: No Supports: Yes Resolution: 0.2 Infill: 10% Notes: You can use these settings or customize them as you see fit. Post-Printing Requirements: LED light strip: https://goo.gl/wsdI7G M8 threaded rod: https://goo.gl/2XoycC (approximately 40cm long) A few M8 nuts: https://goo.gl/Tj2WLL Washers: https://goo.gl/6nbxf9