Led streep Holder Anet A8 3d print

thingiverse

Light your 3D print now by following these steps: Add supports to your model using a light-based system. You can use any LED strip once you've selected the one that suits your needs. Apply the adhesive and attach it to a plastic or wooden rod, which should be approximately 380 mm long and 16 mm thick, with a thickness of 2mm. The circuit requires a switch, and if the voltage matches the current supplied by your 3D printer, you can use it without any issues. Print Settings: Printer: Anet A8 Rafts: No rafts will be used for this print job. Supports: No supports are needed for this model. Resolution: The resolution is set to 0.2 layers per layer. Infill: The infill percentage is set to 50 or 60%. Notes: Set the PLA temperature to 200 degrees Celsius. Set the HotBed temperature to 60 degrees Celsius.