LED Solar light hood for planter

thingiverse

4/18/2019 1730 Added two-inch and three-inch risers with splits since I'm working with a different PLA that shrinks a bit, and the split ends can help with about 2% shrinking. 4/3/2019 1700 Merged Hood V3 and just the bottom half; I have yet to print V3 but would use rafts if merged. I will print V3's bottom half and glue it to version 2. The thought was adding aluminum tape in it for extra light via reflection. Version 1 didn't fit LED solar lights well, so I had to wrap blue tape for a snug fit; then I thought why not do two lights. The slotted ends of the two- and three-inch risers only go one inch deep; the non-slotted end goes all the way. Press-fit pins in and use lock blocks to stabilize or glue. Scale as needed. My planter pictured is 75% - the 2/3 inch risers were based on that and are loose for easy removal. This is a work in progress. This is a Solar panel and single LED light holder for indoor growing; it's based on https://www.thingiverse.com/thing:903411. I'm not remixing it, I'm adding to it. So far, I'm making a hood that will be above it, supporting the LED light with battery and solar panel. (Wal-Mart has them for $0.97US - couldn't find a link - and the 99cent only store also has them). This design is based on previously mentioned planter; but my printer can't print that size. I've previously printed this design at 60%, and I'm now printing it again at 75% (now shown); The first half is done printing, and I have been using it for measurements.