Led Panel Mount for i3 Mega S

thingiverse

Mounting a 12V, 60mm x 40mm LED Panel atop an Anycubic 3 Mega S Frame: A Step-by-Step Guide to Installation To successfully mount a 12-volt, 60 millimeter by 40 millimeter LED panel at the top of your Anycubic 3 Mega S frame, follow these straightforward steps. First, ensure there is ample space at the top of the frame for both the panel and the switch. Typically, the top section of the printer's frame provides more than enough room for this setup. Next, prepare the LED panel by carefully removing any protective covering from its surface. This will expose the adhesive side, ready to be applied directly onto the frame. Now, locate the area at the top of the Anycubic 3 Mega S where you plan to mount both the LED panel and the switch. Clean this section thoroughly with a soft cloth or brush to remove any dust or debris that might interfere with adhesion. Apply a thin layer of adhesive backing from the LED panel directly onto the cleaned frame area, ensuring complete coverage. If necessary, use additional strips to secure the panel in place.