LED holder for Tarmo4

thingiverse

This is a tailored adaptation of the rear and front shock mounts specifically designed to secure some high-intensity LEDs. The configuration is optimized for six LEDs in the front and three in the rear, ensuring seamless integration with your existing setup. To power these vibrant lights, I cleverly tapped into the RC transmitter's electrical supply. For the front lights, a precise 100 Ohm resistor was used, while the rear ones utilize a slightly higher 220 Ohm resistance. To maintain consistency, follow the same printing parameters as those applied to the original components. Supportive structures are only required for the front mounts.