LED Holder for Pirahna Super-Flux RGB LEDs and Williams/Bally Pop Bumper Bodies

thingiverse

LED Holder for Pirahna Super-Flux RGB LEDs and Williams/Bally Pop Bumper Bodies Created by Outpost Kodelia (https://www.thingiverse.com/OutpostKodelia) License: Creative Commons - Attribution This LED holder is specifically designed to fit inside standard Williams/Bally pop bumper bodies and securely mount a Pirahna Super-Flux RGB LED bulb. It utilizes stock screws/holes for mounting and routing wires through to the bottom of the playfield. First, install the bulb on the side with the triangle mark, ensuring that the corner notch on the LED aligns perfectly with the triangle. On the backside, solder wires perpendicular to the terminals according to the labels provided. Next, route the wires through the neighboring holes so they emerge from the top of the adapter. Remove your old light and screws holding the bumper down, then run the wires down through the body's wire holes. Tighten the wires snugly and screw it back into place using original screws, aligning countersunk screw holes with the original screw holes. Finally, connect to your controller and enjoy the vibrant display! Some pop bumper bodies may not have raised rings around wire holes; if this is the case, you can route wires directly from soldered pins down into body's wire holes. Pictures for both scenarios are attached. When installing, be aware that depending on original screw length, you might need to use screws up to 1/8" (or 4mm) longer to account for extra height. For optimal results, we recommend using 26ga wire to ensure all four wires fit through the two wire holes. This design should also work with any other RGB LED featuring 5mm square pin spacing. Version v0.1 - Initial creation. Print recommendations: * Supports: No * Reduce speed for improved accuracy and reduced strings around small details * Print at high resolution This design is compatible with the following Williams/Bally parts: * 03-7443-5 * 3A-7443 * Wico 19-0155 * 545-5199-00