LED Holder

thingiverse

Create a holder for Digitron LED Modules. Recently, I purchased two 1-Watt LED Modules at Frys. The source is http://www.alltronics.com/cgi-bin/category.cgi?item=LHA06B12N. To easily mount and illuminate my work area, I sought a simple holder design. The reprinted instructions featured on a smoother belt, contrasting the initial bubbled version. A successful DIY belt was inspired by http://www.thingiverse.com/thing:5648. For assembly, the module sits under the rear tabs and attaches to front pegs. Wire placement should be towards the back. On the Z-axis, remove a thumbscrew from the plastruder, pass it through the designated hole (enlarge if necessary), and reassemble. Repeat for the other side. Run wires via the two square holes on the Z-axis, secure them, and connect to 12V as shown in http://www.thingiverse.com/thing:5771.