LED Hex Light

prusaprinters

<p>Cheap and easy LED Hex wall lighting.&nbsp;</p><p>Each Hex side has a pre-perforated slot that can be easily removed allowing the LED strip to flow from one Hex to the next. I have 23 Hex's and ran just shy of 2x 5m LED Strips (300 LEDS).</p><p>I glued the Hex's together with hot glue and used polystyrene plates for the light diffusers, which I think works perfectly, hot glued at a couple of corners to hold them in place.&nbsp;</p><p>The control box is large enough for an ESP8266. I drilled a hole in the bottom edge to also attached a 5v barrel connector for power.&nbsp;</p><p>I used three clips spread out across the installation and 3x large 3M command hanging strips to fix to the wall.&nbsp;</p><p>Its delicate, but been on the wall for a few months now and still looks great.</p><p>&nbsp;</p><p>Polystyrene Plates: <a href="https://www.amazon.co.uk/gp/product/B0085OJJHI/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&amp;psc=1">https://www.amazon.co.uk/gp/product/B0085OJJHI/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&amp;psc=1</a></p><p>Power Jack Socket:</p><p><a href="https://www.amazon.co.uk/gp/product/B07X9MMJL2/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&amp;psc=1">https://www.amazon.co.uk/gp/product/B07X9MMJL2/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&amp;psc=1</a></p><p>Command Hanging Strips:</p><p><a href="https://www.amazon.co.uk/gp/product/B086NCXFBF/ref=ppx_yo_dt_b_asin_title_o09_s00?ie=UTF8&amp;psc=1">https://www.amazon.co.uk/gp/product/B086NCXFBF/ref=ppx_yo_dt_b_asin_title_o09_s00?ie=UTF8&amp;psc=1</a></p><p>&nbsp;</p><p>All printed support free, in PLA, 0.2mm layer height.</p><p>&nbsp;</p>