LED Flood Light 50° with active cooling

prusaprinters

I designed this flood light with 365 nm UV LEDs and a matching UV pass filter in mind but you could also not subject yourself to invisible eye damaging radiation and opt for any other LEDs in the visible spectrum of light. If you want to use UV LEDs be aware of the risks and take all necessary safety precautions while working on and using the LEDs.Electronic Components8x 3W COB LEDs of your choice1x voltage and current regulator like the “arceli buck boost converter”1x usb-c trigger module like the “ALAMSCN PDC004-PD” 2x Fans 50x10 mmOther Componentsheat sink 110x22x18 mm with its fins running along the long side4x M4x13 mm screwsthermally conductive gluereflective foilmirror foil for visible LEDsaluminum foil for UV LEDsoptional for UV light: band-pass filter 150x50x2 mm for the same wavelength as the LEDsBoth parts are designed to be printed without support.Flood Light Coolingheat sink gets pressed inLEDs get soldered together and glued onto the heat sinkother electronics get mountedwhile doing the wiring notice the position of the cutouts in the reflector for the wires to go throughFlood Light Reflectorthe reflective foil must be glued onto the inside walls of the reflectorthe reflector can be mounted atop the heat sink from the open side (opposite to the mounted circuit boards) and should be held in by the clips on the other sidethe clamping mechanism holding the two parts together can be seen in the 5th picture