LED Flashlight for LiPo

thingiverse

Create a robust flashlight design that suits your needs. I employed a high-capacity battery pack consisting of three lithium-polymer cells (1S3P LiPoly) with a total capacity of 3750mAh, which can power the light continuously for approximately 10 hours at a steady output of 1 watt. The design was created using Autodesk Inventor software, and I have included all relevant files. To ensure stable printing, use support structures to compensate for overhanging features. Required components: 1W LED Lithium-polymer battery (or substitute with an alternative energy source) Connectors for attaching the battery Cable for wiring 1.5Ohm resistor (dependent on specific component selection; works well in conjunction with 200mm Kanthal wire) Three M3 screws Note: My Inventor model is scaled down by 10% during export, so increase the scale to 1000% for accurate measurements before printing.