LED Cable Buddy

thingiverse

Working on an LED project I was trying to connect an LED strip connector to a the 4 wires of my LED wire cables. The ends were always fraying and sneaking over to the other lines and shorting everything out. I really didn't want to bust out my soldering iron every time I needed to make a connection, so I decided to see if I could design a 3D printed solution. And here it is! Each piece takes less than a minute to print. Just clip the cable buddy under the pins and secure the wires into each lane. Then set the wires into their lanes and close the cover down. It may take some force close, but that may also be because I forgot to adjust resolution on the final print. 0.15 or less is best. Let me know if it helps you at all!