Led base for BIG BEN Tower

thingiverse

Building a Strip of LEDs at 12 Volts for Aquariums on the Beautiful Tower by MakeALot Let's dive into assembling an LED strip at 12 volts that will shine in your stunning aquarium tower created by MakeALot. To begin with, choose a spot near the area where your tank pump will sit since that location should offer better support and stability to all your gear. Next, locate the wires and strip them away from their insulation using pliers or any suitable wire stripper tool – this can get somewhat dirty so be prepared to handle that task without worrying too much about mess. Assemble the Strip by Connecting Wires and LEDs First, place one end of each of the power cables inside one side connector on the board, following through as if these would plug right in without needing an adapter (this ensures optimal connections without using a middleman device), secure them well then make sure all four ends get covered before proceeding to next steps like checking wire thickness so they can actually hold voltage applied across multiple layers. The final check includes verifying all wiring was properly soldered; each connection between component groups on opposite sides where needed ensuring continuity across entire assembly even when disconnected briefly due simply inspecting visual cues signs resistance reduction once joined fully again afterwards recheck previous checks too – basically it should all be fine before actually using power